BASEANTENNATYPE
Sets the antenna type of the base receiver
|
Platform: |
OEM719, OEM729, OEM7500, OEM7600, OEM7700, OEM7720, PwrPak7, CPT7, CPT7700, SMART7 |
Use the BASEANTENNATYPE command to set the type of antenna connected to the base receiver from which this receiver is receiving RTK corrections. There are two sources of antenna information:
- An internal table
The firmware contains a set of predefined antenna and radome types taken from the IGS ANTEX file. Refer to Table: Antenna Type and Table: Radome Type for the antennas currently supported. - User-defined antennas
User-defined antenna types can be entered using the ANTENNATYPE command.
The THISANTENNATYPE command is used to set the type of antenna being used with this receiver.
Message ID: 1419
Abbreviated ASCII Syntax:
BASEANTENNATYPE AntennaType [RadomeType] [CorrectionType] [StationId]
ASCII Examples:
BASEANTENNATYPE NOV702
BASEANTENNATYPE USER_ANTENNA_1
|
Field |
Field Type |
ASCII Value |
Binary Value |
Description |
Format |
Binary Bytes |
Binary Offset |
|
1 |
Command header |
- |
- |
BASEANTENNATYPE header This field contains the command name for abbreviated ASCII or the message header for ASCII (see page 1) or Binary (see page 1). |
- |
H |
0 |
|
2 |
AntennaType |
Antenna type |
Enum |
4 |
H |
||
|
3 |
RadomeType |
Radome type |
Enum |
4 |
H+4 |
||
|
4 |
CorrectionType |
Correction type |
Enum |
4 |
H+8 |
||
|
5 |
StationID |
Char [8] or ANY |
Base station ID |
Char |
8 |
H+12 |
|
The latest information can be obtained from the National Geodetic Survey (NGS) site www.ngs.noaa.gov/ANTCAL.