WIFIMODE
Configure the receiver Wi-Fi mode
Platform: |
PwrPak7, SMART7-I, SMART7-SI, SMART7-W |
PwrPak7M and PwrPak7Q variants do not support this command.
Use this command to enable, disable or set the operating mode of Wi-Fi on the receiver. This command is also applies any Wi-Fi configuration changes specified by other Wi-Fi commands such as WIFIAPCHANNEL.
Message ID: 2144
Abbreviated ASCII Syntax:
WIFIMODE mode
Factory Default:
WIFIMODE AP
Example:
WIFIMODE CLIENT
WIFIMODE OFF
Field |
Field Type |
ASCII Value |
Binary Value |
Description |
Format |
Binary Bytes |
Binary Offset |
---|---|---|---|---|---|---|---|
1 |
Command header |
- |
- |
WIFIMODE header This field contains the command name for abbreviated ASCII or the message header for ASCII or Binary. |
- |
H |
0 |
2 |
mode |
OFF |
0 |
Power off the Wi-Fi module |
Enum |
4 |
H |
AP |
1 |
Configure the Wi-Fi module as an Access Point (AP) |
|||||
CLIENT |
2 |
Configure the Wi-Fi module as a Client/Station |
|||||
ON |
3 |
Supply power to the Wi-Fi module, but do not configure it. |
|||||
CONCURRENT |
4 |
Configure the Wi-Fi module as both an access point and Client/Station simultaneously. When configured in this mode it is possible to connect the receiver to an access point and for Clients/Stations to connect to the receiver simultaneously. |