Common RF and Data Connectors

This low profile connector is often used with a board to board RF barrel interconnect instead of a cable.

Examples of receiver cards with this RF connector are the OEM7700 and OEM7720.

The largest RF connector on current NovAtel receiver cards. NovAtel receiver cards may use a right angle variant.

An example of a receiver card that uses this RF connector is the OEM719.

Smaller than the MCX connector.

Examples of receiver cards that use this RF connector are the OEM729 and OEM7600.

This threaded RF connector is used on OEM7 enclosures.

An example of a NovAtel product that uses this RF connector is the PwrPak7.

This is a quick connect/disconnect connector. This RF connector is used on some NovAtel products.

Examples of NovAtel products that use this RF connector are the OEM7 Development kit and the GT7800.

This threaded RF connector is used OEM7 enclosures.

Examples of OEM7 enclosures that use this RF connector are the PwrPak7D and the CPT7.

This is a very large threaded connector used for RF equipment.

An example of a NovAtel product that uses this RF connector is the GNSS-750 Wideband Antenna.

NovAtel uses the 60 pin variant for this high density keyed connector. The male being the TEMS connector, and the female being the SEMS connector. Be careful when connecting as there is a chance of bending pins.

Examples of NovAtel products that use this connector are the OEM7600, OEM7700 and OEM7720.

NovAtel uses many types of LEMO connectors and are usually referred to as (number of pins)-pin LEMO connector. It is used for power, data, or both. Match the red keying symbol when plugging it in.

An example of a NovAtel product that uses this connector is the FlexPak6, which uses the connector for power only.