Make the Electrical Connections
To make the electrical connections you will need a 3/32” a hex key, the wiring harness and the partially assembled SPAN IMU from Install the LN-200 Sensor Unit. Now follow these steps:
-
Attach the LN-200 wire harness to the mating connector on the LN-200. Check that the connector is fully seated, as shown in Figure: Attach Wiring Harness.
-
Connect the Samtec connector at the other end of the wiring harness to the corresponding connector on the internal IMU card, as shown in Figure: Attach Samtec Connector. Ensure that the connector is locked in place.
