UNASSIGN

Unassigns a previously assigned channel

Platform:

OEM719, OEM729, OEM7500, OEM7600, OEM7700, OEM7720, PwrPak7, CPT7, CPT7700, SMART7, SMART2

This command cancels a previously issued ASSIGN command and the SV channel reverts to automatic control (the same as ASSIGN AUTO).

Message ID: 29

Abbreviated ASCII Syntax:

UNASSIGN channel [state]

Input Example:

UNASSIGN 11

Issuing the UNASSIGN command to a channel that was not previously assigned by the ASSIGN command has no effect.

For dual antenna receivers:

On the primary antenna, the SV channel is from 0 to N-1, where N is the number of channels in the primary antenna channel configuration.
On the secondary antenna, the SV channel count is from at N to N+(M-1), where M is the number of channels in the secondary antenna SV channel configuration.
Even though L-Band channels cannot be configured with ASSIGN or UNASSIGN, they are included when determining N.

The ASSIGN and UNASSIGN commands are not accepted for L-Band channels. The ASSIGNLBANDBEAM command should be used for L-Band channels.

Field	Field Type	ASCII Value	Binary Value	Description	Format	Binary Bytes	Binary Offset
1	Command header	-	-	UNASSIGN header This field contains the command name for abbreviated ASCII or the message header for ASCII (see page 1) or Binary (see page 1).	-	H	0
2	channel	0 to N-1, where N is the number of the last GNSS channel in the current channel configuration		Channel number reset to automatic search and acquisition mode	Ulong	4	H
3	state	These return SV channel control to the automatic search engine immediately (see Table: Channel State)		Set the SV channel state (currently ignored)	Enum	4	H+4