SOFTLOADSREC

Sends an S-Record to the receiver for the SoftLoad process

Platform:

OEM719, OEM729, OEM7500, OEM7600, OEM7700, OEM7720, PwrPak7, CPT7, CPT7700, SMART7, SMART2

Use this command to send S-Records to the receiver for the SoftLoad process. Refer to Updating Using SoftLoad Commands for more information about the SoftLoad process.

After each SOFTLOADDATA command, the user must wait for the OK or ERROR command response before proceeding. This response is guaranteed to be output from the receiver within 15 seconds from the time the command was received by the receiver. If an error response is returned, consult the SOFTLOADSTATUS log for more detail.

This command can only be sent to the receiver when the SOFTLOADSTATUS log reports READY_FOR_SETUP or READY_FOR_DATA.

Message ID: 477

Abbreviated ASCII Syntax:

SOFTLOADSREC s-record

Input Example:

SOFTLOADSREC “S30900283C10FAA9F000EF”

Field	Field Type	ASCII Value	Binary Value	Description	Format	Binary Bytes	Binary Offset
1	Command header	-	-	SOFTLOADSREC header This field contains the command name for abbreviated ASCII or the message header for ASCII or Binary.	-	H	0
2	s-record	-		ASCII S-Record string copites from firmware *.shex file	String [515]	variable1 In the binary case, each string field needs to be NULL terminated and additional bytes of padding added to maintain 4-byte alignment, up to the maximum defined by the string size. The next defined field starts immediately at the next 4-byte alignment following the NULL.	H
3	Reserved	-	1	Reserved. Set to 1 in the binary case	Ulong	4	variable