SBASECUTOFF

Sets SBAS satellite elevation cut-off

Platform:

OEM719, OEM729, OEM7500, OEM7600, OEM7700, OEM7720, PwrPak7, CPT7, CPT7700, SMART7, SMART2

This command sets the elevation cut-off angle for tracked SBAS satellites. The receiver does not start automatically searching for an SBAS satellite until it rises above the cut-off angle (when satellite position is known). Tracked SBAS satellites that fall below the cut-off angle are no longer tracked unless they are manually assigned (see the ASSIGN command).

This command permits a negative cut-off angle and can be used in the following situations:

• The antenna is at a high altitude and can look below the local horizon

• Satellites are visible below the horizon due to atmospheric refraction

Use the ELEVATIONCUTOFF command to set the cut-off angle for any system.

Message ID: 1000

Abbreviated ASCII syntax:

SBASECUTOFF angle

Factory default:

SBASECUTOFF -5.0

ASCII example:

SBASECUTOFF 10.0

Field	Field type	ASCII value	Binary value	Description	Format	Binary bytes	Binary offset
1	Command header	-	-	SBASECUTOFF header This field contains the command name for abbreviated ASCII or the message header for ASCII or Binary.	-	H	0
2	angle	±90.0 degrees		Elevation cut-off angle relative to horizon	Float	4	H