RTKTRACKINGCONTROL

Automatic selection of tracking signal type based on incoming base station observations

Platform:

OEM719, OEM729, OEM7500, OEM7600, OEM7700, OEM7720, PwrPak7, CPT7, CPT7700, SMART7

Controls automatic selection of tracking signal type based on incoming base station observations. This command only applies to single GPS/GLO L2 channel configurations that can auto switch between L2P and L2C. The RTKTRACKINGCONTROL command setting takes precedence over the FORCEGPSL2CODE command and FORCEGLOL2CODE command. If this command is set to AUTO, the receiver will always match signal types to incoming corrections.

Message ID: 1351

Abbreviated ASCII Syntax:

RTKTRACKINGCONTROL [Mode]

Factory Default:

RTKTRACKINGCONTROL AUTO

ASCII Example:

RTKTRACKINGCONTROL DISABLE

Field	Field Type	ASCII Value	Binary Value	Description	Format	Binary Bytes	Binary Offset
1	Command header	–	–	RTKTRACKINGCONTROL header This field contains the command name for abbreviated ASCII or the message header for ASCII or Binary.	–	H	0
2	Mode	Disable	0	Disable automatic selection of tracking signal	Enum	4	H
		Auto	1	Automatically match the signal type to the incoming corrections. Default = Auto