ITWARNINGCONFIG

Configure the sensitivity level for the Jammer Detected bit

Platform:

OEM719, OEM729, OEM7500, OEM7600, OEM7700, OEM7720, PwrPak7, CPT7, CPT7700, SMART7

This command is used to configure the sensitivity level for setting the Jammer Detected bit in the Receiver Status word in the RXSTATUS log. Warning level 0 is the most sensitive, while level 3 is the least sensitive. Warning level 0 means the Jammer Detected bit can be set even when minor interference is detected. By default, the warning level is set at 3.

On dual antenna receivers (OEM7720, PwrPak7D, PwrPak7D-E1, PwrPak7D-E2 and CPT7), the ITWARNINGCONFIG setting applies to both antenna inputs.

Message ID: 2289

Abbreviated ASCII Syntax

ITWARNINGCONFIG WarningLevel [Reserved]

Factory Default:

ITWARNINGCONFIG 3

ASCII Example:

ITWARNINGCONFIG 0

Field	Field Type	ASCII Value	Binary Value	Description	Format	Binary Bytes	Binary Offset
1	Command header	–	–	ITWARNINGCONFIG header This field contains the command name for abbreviated ASCII or the message header for ASCII (see page 1) or Binary (see page 1).	–	H	0
2	WarningLevel	0		Detection warning sensitivity level 0 = most sensitive 3 = least sensitive	Ulong	4	H
		1
		2
		3
3	Reserved	0		Reserved	Ulong	4	H+4