DATADECODESIGNAL
Enable/Disable navigation data decoding for GNSS signal
|
Platform: |
OEM719, OEM729, OEM7500, OEM7600, OEM7700, OEM7720, PwrPak7, CPT7, CPT7700, SMART7, SMART2 |
Use this command to enable or disable framing and decoding of the navigation message for each GNSS signal. When disabled, the receiver will no longer output raw frame data, ephemeris or almanac data from that signal. Signals which do not yet have the built in capability to output raw frame data are not configurable. Note that if a primary signal such as GPSL1CA is disabled, it may cause the receiver to no longer function normally because this signal’s data is essential for setting receiver time and computing positions.
The default setting for each GNSS signal, and which signals can be configured, is available in Table: GNSS Signal Default and Configurability. The table also lists if the signal's navigation message is used to compute the satellite position. For the binary value and a longer description for each signal, see Table: Signal Type.
Message ID: 1532
Abbreviated ASCII Syntax:
DATADECODESIGNAL signaltype switch
Abbreviated ASCII Example:
DATADECODESIGNAL GPSL2C enable
|
Field |
Field Type |
ASCII Value |
Binary Value |
Description |
Format |
Binary Bytes |
Binary Offset |
|
1 |
Command header |
- |
- |
DATADECODESIGNAL header This field contains the command name for abbreviated ASCII or the message header for ASCII or Binary. |
- |
H |
0 |
|
2 |
signal type |
GNSS Signal Type |
Enum |
4 |
H |
||
|
3 |
switch |
Disable |
0 |
Enable or disable the data decoding |
Enum |
4 |
H+4 |
|
Enable |
1 |
||||||